Real Estate & Equipment Consignment Auction    19F

60" cleanup bucket, thumb, enclosed rops cab and canopy, aux hydraulics, cat walks, auto greaser on unit since new. All bucket pivot pins done Feb 2019 8,900 hrs

sells with 60" & 36" clean up buckets, thumb, high flow hydraulics, 3rd hydraulic valve and auxiliary controls to operate twist-a-wrist bucket, engine Pro heater, Cab has radio, heat & A/C, positive air shut down, cat walks, stump pans, a very clean unit with only 10,555 engine hours

sells with 60" & 36" clean up buckets, thumb, high flow hydraulics, 3rd hydraulic valve and auxiliary controls to operate twist-a-wrist bucket, Cab has radio, heat & A/C, positive air shut down, cat walks, stump pans, a very clean unit with 12,084 engine hrs, very tight well looked after unit

sells with (3) buckets & thumb, cab, A/C, heat, 4571 hours

came off the Cat 320 excavator

Volvo powered, power shift transmission,, 750/65R-25 rubber, 12,582 engine hours, rock truck just came off a job and is in real good shape

twin International 5.9 litre engines, Funk 7 speed power shift with electronic shift transmissions, 29.5 x 25 rubber, rear push block, clean unit with approx 5900 hrs, bowl is in good shape, unit has been parked for the last two years

Q/A bucket, cab, A/C, heat, radio, all 4 brand new 20.5R X25 tires. 3rd hydraulic valve, only 16,955 hours, very clean loader.

Q/A bucket, 25.5 x 25 rubber, 3rd hydraulic valve, hours are not certain but we are thinking under 10,000 due to condition of the loader. Pins are all tight, no rust on body, the structure is above average for the it's age.

bucket, cab, heat, power shift transmission, ROPS cab roll over protection, pallet forks (not quick attach bucket) 23.5-25 rubber, 17,384 hrs showing

cab, ROPS canopy, full screen package, C frame with twin tilt, angle blade, rear multi shank ripper, only 13,905 engine hours. In the past 280 hrs $91,646.00 was spent on repairs and we have all work orders on hand. Break down on repairs, Feb 2016 at 13626 hrs a rebuilt torque convertor was installed costing $16,656.00, Feb 2019 at 13884 hrs, all new undercarriage except pads, transmission rebuilt,, replaced pivot shaft bearings in track frame, new bushings in track frame, new pins in hard bar, new axle shaft seals, costing $64,180.00. March 2019, new starter, rebuild RH & LH brakes at $10,910.00.

Cab, heat, cab canopy, 6-way dozer blade, rear drawbar, engine side shields, shows 10,752 engine hours, runs and operates great.

twin tilt dozer blade, rear ripper, full canopy, block heater, parts book, shop manuals, full set of extra filters,, Sept 2016 rebuilt hydraulic pump, January 2009, new radiator, February 2009 replaced transmission & torque, transmission pump and resealed steering clutch's, February 2009 totally rebuilt the Cummins engine from top to bottom including new oil lines and batteries for the sum of $38,538.00. We have all work orders on hand. 2016 all new pads & bolts on both tracks. Undercarriage is in real good shape and new corner bits on blade. This crawler is in tip top shape crawler dozer.

76" bucket, cab, heat, A/C, radio, high flow hydraulics,12X16.5 rubber, very clean in above average condition

Cab, heat, A/C, high flow hydraulics, sells with one bucket, 3700 hours

bucket, good 10-16.5 rubber, 2651 hours

4 cyl diesel engine, 5,000 lb lifting capacity, 5,600 hrs

Kubota diesel engine, Q/A bucket, next to new tires, 2621 hrs