4 Photos 21DD0510-004
$217,000
winch, guarding, undercarriage 70% measured
4 Photos 21DD0566-005
$95,000
front mount Q/A hydraulic angle blade, rear ripper, snow wing, cab, heat, A/C, radio
4 Photos 21DD0510-001
$119,000
Caterpillar C7.1 Acert engine, Rops wide cab, twin seats, rear deck with Atlas 42-A3 knuckle boom crane, 5 section 25' reach with wireless control, only 3013 hrs
4 Photos 21DD0588-002
$75,000
ROPS, factory cab w/air & radio, C-frame twin tilt 14' dozer blade, (3) shank ripper, Webasto heater, 30" tracks, 16,772 hrs
4 Photos 21DD0801-001
$138,000
32" wide tracks, 71" cleanup bucket, 38" digging bucket, cab guard, extra set of hydraulic outlets on boom, 1475.6 hrs
4 Photos 21DD0557-007
$79,000
Q/A heavy tooth bucket, 3rd valve, high flow hydraulics, A/C, heat, radio, low hours
4 Photos 21DD0516-006
$163,000
regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, low profile, complete w/ ripper and three shanks, change condenser and charge a/c (2016), replace circle drive motor (2017), rebearing circle and slip clutch (2017), rebuild welded and machine mould board (2019), line bore and weld four bores press, reconditioned slider pockets (2019), good radial tires. 2017 is the last year of the 'H' series before joysticks of the 'M' series.
4 Photos 21DD1027-001
$77,000
6 way dozer, Full ROPS canopy cab, heat, A/C, rear cab window screen, I barrel 3 shank ripper, engine side guards, fender guarding, 3306 Cat engine, Wabasto engine heater, power shift transmission, 12,166 hrs
4 Photos 21DD0806-001
$108,000
quick coupler, hydraulic thumb, 66" cleanup bucket & 40" digging bucket, cab heat and A/C, Proheat system, 5217 hrs
4 Photos 21DD0516-001
$71,000
CAT C-13 engine, has super lifters, regular maintenance of all fluids and filters w/Shell Rotella. Reconditioned stick cylinder (2018), installed Reman hydraulic motor group (2012), lift cylinders redone (2016), all the valves for all the controls replaced (2017), changed injectors, 10,869 hrs. Two buckets sell with the excavator. This is a strong machine.
4 Photos 21DD0516-004
$139,000
push-pull rigging, regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, rebuilt differential (2016-$17,900), new fuel transfer pump (2012), new A/C compressor (2013), new CAT transmission (2014-$27,300), New Michelin 37.25-R35 radial tires (<500 hrs wear), front radial tires (2015-$29,406), back motor rebuilt in 2015 at 12,000hrs (119hrs on motor), regular maintenance on all wear items, rebuild cushion ride cylinder (2014), replace bail pump (2016-$4,600), replaced turbo (2015), new harmonic balancer on front engine (2016), install ejector valve on cylinder (2017-$3,965), new ejector roller (2017), new Schrader valve (2019), 12,119 hrs showing
4 Photos 21DD0510-003
$72,000
Cummins engine,hydrostatic transmission, cab, A/C, heat, radio, 1350 hrs
4 Photos 21DD0566-004
$45,000
6 way dozer, cab, heat, A/C, radio, full ROPS canopy, heavy front rad guard, all screens around cab, Carco 50BPS winch, drawbar, good under carriage
4 Photos 21DD0516-002
push-pull rigging, regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, installed long blocks from Finning in front and back motors (2012-$28,610), valve set completed (2019). 3726 hrs
4 Photos 21DD0510-002
$78,000
6 way dozer, cab, A/C, heater, radio, full ROPS canopy,window screens, rear mount winch, only 2394 hrs
4 Photos 21DD0516-007
$189,000
regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, regular maintenance of all wear items - feet and cleaning bars, new compressor and alternator (2012), new alternator (2015), new muffler (2017). Replaced u-joints, seal between motor and transmission, oscillating bearing, cup and seal on back, rebuild wheels and install new cleaning bars and replace feet (2018-$36,000). Front and rear crankshaft seals on engine, resealed torque seal housing to transmission case (2020 - $15,000). 11,634 hrs
4 Photos 21DD0516-003
push-pull rigging, regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, installed long blocks from Finning in front and back motors (2012-$28,610), valve set completed (2019), new radial tires (2018), replaced housing and axle (2016-$10,913), replace injection pump and injectors (2019), Reman turbo (2017). 6335hrs
4 Photos 21DD0588-001
$41,000
hydraulic thumb, 37" bucket, 31.5" tracks, 16,150 hrs
4 Photos 21DD0516-005
$81,000
CAT V-12 engine, regular maintenance of all fluids and filters w/Shell Rotella, authentic CAT filters used for all fluids and air, hydraulic pump rebuild, new air seat, installed air conditioner and heater box, rebuilt dozer valve for ripper (2016), new exhaust (2018), installed reconditioned lift cylinders from Union Tractor (2013). This dozer was purchased totally rebuilt from Southwest Machinery Sales out of Arizona in 2010. This is a nice running unit that has never worked in the winter.
4 Photos 21DD0565-001
$26,000
JD diesel engine 6466AT-12, newer 17.5 - 25 tires front, 25% 17.5 - 25 tires rear, runs and operates well
4 Photos 21DD1023-002
$25,000
fully enclosed heated cab, a/c, 12-16.5 rubber, electric quick attach, JD C76 bucket, 1330hrs
4 Photos 21DD0518-002
$43,000
6 way dozer, 115" blade, 25" wide track, cab, a/c, heater, rear hydraulic winch. Owner verifies there is approx. 3,800-4,000 hrs on unit.
4 Photos 21DD0400-008
$16,750
Kubota diesel engine, 12" tooth bucket , 13" smooth bucket, 3426 hours, trailer has 12" tires and spring suspension, fold down rear ramp
4 Photos 21DD0539-001
$18,250
6' bucket, hand & foot controls, Hi-flo hydraulics, 1500 hrs showing
4 Photos 21DD0518-001
$48,000
6 way dozer, 10' blade, 24" wide tracks, cab, a/c, heater, rear hydraulic winch, approx 6200 hrs
4 Photos 21DD0557-001
$23,000
A/C, heat, bathroom, TV, radio, satellite, microwave, fridge, power cord, 6000 lb axles, 235/R16 tires on aluminum rims, Alberta registered
4 Photos 21DD0538-001
Perkins 98 HP engine, hydrostatic transmission with high/lo, cab, heater, front blade, rear ripper, owners manual, 15-19.5 tires, 1470 hrs showing
4 Photos 21DD0201-001
$7,600
20 ft platform height, 9 ft x 8 ft 6 in. platform, 24 ft x 6 ft 8 in. trailer, spring suspension, 235/80R16, 3 cyl diesel, rear controls, (4) manual stabilizers, 645 hrs showing, last Alberta CVIP 10/19
4 Photos 21DD0557-002
$13,000
A/C, heat, bathroom, TV, radio, satellite, microwave, fridge, power cord, spray foam insulated floor, 5000 lb axles, 235/R16 tires on steel rims, Alberta registered
4 Photos 21DD0400-009
$5,800
Kohler 22 HP electric start engine, 36" dig depth
4 Photos 21DD0530-001
$11,500
International 6 cylinder diesel engine, front blade, center mounted scarifier with teeth, cab, heater all rear tires new in 2020
4 Photos 21DD0407-001
$24,000
4 ft Q/A bucket, 1693 hrs, Undercarriage in real good condition.
4 Photos 21DD0527-006
$3,300
on propane and works well
4 Photos 21DD0400-003
$4,200
diesel engine, with remote
4 Photos 21DD0802-002
4308 hrs
4 Photos 21DD0528-001
$4,250
hydraulic pump, front truck bumper, horn, log grapple, continuous swing
4 Photos 21DD1029-004
$3,750
12-16.5 front tires, 9.50R16.5 rear tires
3 Photos 21DD0535-002
$4,550
fits 200 series Weldco Beals, w/new blade and hydraulic motor
4 Photos 21DD0400-002
$6,100
twin cylinder diesel engine
4 Photos 21DD0802-001
$2,850
20 kw generator, 4 lights, 9013 hrs
4 Photos 21DD0400-001
$3,800
Hatz diesel engine
4 Photos 21DD0516-009
fits D9-L or D10-N, from tip to tip it is 16' wide and 6' tall
4 Photos 21DD0400-010
$1,850
GX270 Honda engine
4 Photos 21DD0802-003
7010 hrs
4 Photos 21DD0563-001
$525
came off Caterpillar 816 self propelled packer
4 Photos 21DD0516-008
$410
37.25R35 used
4 Photos 21DD1063-001
11.6' wide, fits D6
4 Photos 21DD0400-012
$1,400
GX160 Honda engine
3 Photos 21DD1056-003
$825
fits 200 series excavator
4 Photos 21DD0400-011
4 Photos 21DD1079-002
$1,000
fits D6D or D6C Cat wide pad
4 Photos 21DD0578-001
4 Photos 21DD0400-004
Honda 4 cycle engine
3 Photos 21DD0535-003
$1,150
fits CAT 14H/14M Grader
4 Photos 21DD0400-005
$875
1 Photos 21DD0535-009
4 Photos 21DD1021-001
$500
4 Photos 21DD0400-006
(1) is almost complete
4 Photos 21DD1056-001
$200
1.6 Litre Ford industrial gas engine, not running
2 Photos 21DD1029-001
$1,100
fits 12"x16.5 skid steer tire
4 Photos 21DD1051-001
$80
3 Photos 21DD0400-007
$10